The For Estroost
Meta to cut 10,000 jobs in second...
Elevating Your Office Attire...
Beauty and Wellness Secrets...
31°C, New York
The For Estroost

Weekly Updates

Let's join our newsletter!

Do not worry we don't spam!

The For Estroost

A Beginner's Guide to Coppicing Hazel in Woodland

Why Coppicing Hazel Is Worth the Effort

Coppicing is one of the oldest woodland crafts in Britain, and hazel is the tree that suits it best. Rather than felling a tree outright, you cut its stems back to near ground level on a regular cycle and let it regrow from the same base — the stool. Hazel has evolved to do this readily: cut it in winter and by midsummer you will have a cluster of vigorous new shoots, each capable of becoming a straight rod within a few seasons.

For a small woodland owner or a keen conservation volunteer, coppicing delivers on three fronts at once. It produces useful material for rustic crafts, it keeps the wood healthy by letting light reach the woodland floor, and it creates a mosaic of habitats that many of our declining species depend on. A well-managed hazel stool can be cut again and again for well over a century, and some stools in old coppice woods are thought to be many hundreds of years old.

Timing Your Cut Correctly

The golden rule is to cut while the tree is dormant, between late autumn and early spring. In most of the UK, the window runs from November to the end of February. Cutting later, as sap begins to rise, can weaken the stool and cause the bark to slip, which makes for messy rods and slower regrowth.

Work on a dry, frost-free day if you can. Frozen wood is brittle and splits badly, and wet conditions make the woodland floor muddy and the cut stems slippery. Aim to finish the bulk of your coppicing before the birds begin nesting in March, as dense coppice regrowth soon becomes valuable cover for breeding warblers, robins and blackcaps.

How to Make the Cut

The technique is simple but the details matter. Trim each stem as close to the stool as you can manage — ideally no more than 5cm (2in) above ground level — and leave a clean, slightly angled face so rainwater runs off rather than collecting and rotting the wood.

  • Cut on a slight downward slant away from the stool, not into it.
  • Keep the blade sharp. A clean cut heals far better than a torn, crushed stem.
  • Use a bowsaw or loppers for stems up to about 8cm, and a billhook for trimming side branches and snedding.
  • Work from the outside of the stool inwards so you are never cutting towards your own legs.
  • Leave two or three older stems standing on a small number of stools as a bit of structure and a perch for birds.
  • Never cut below ground level or damage the stool itself — that is the engine room of the whole operation.

If you have a large area, divide it into coupes and cut one block each year on a rotation. A seven to ten year cycle suits most hazel. This gives you a steady supply of rods of different sizes and means there is always uncoppiced cover nearby for wildlife to retreat into.

Protecting the New Shoots

Fresh hazel regrowth is soft, sugary and irresistible. From the moment you cut, you are effectively laying out a buffet for deer, rabbits, hares and voles, and without protection a promising stool can be grazed down to nothing in a single season.

  • Fencing is the most reliable answer. Rabbit netting needs to be buried or turned out at the base to stop animals digging underneath; deer fencing needs to be around 1.8m high for fallow and red deer.
  • Individual guards — spiral guards for rabbits and vole collars for the first few years — work well on smaller sites and where only a handful of stools are cut.
  • Brash piles left around the edge of a cut coupe can discourage browsing and provide excellent cover for wrens, hedgehogs and invertebrates at the same time.
  • Check guards after storms and snow, and replace any that have split or been pushed over.

Voles are the sneakiest culprits, gnawing bark at the base of young shoots under cover of grass. Keeping the ground around new stools clear for the first couple of seasons makes a real difference.

The Wildlife That Follows the Cut

A coppiced wood is never static, and that is exactly why it is so rich in life. Immediately after cutting, sunlight floods the floor and triggers a flush of woodland flowers — bluebells, primroses, wood anemone and, in some southern woods, the rare fritillary. Butterflies such as the pearl-bordered and the purple emperor benefit enormously from these open, warm patches.

As the regrowth thickens, the same coupe becomes dense, tangled cover. Dormice favour hazel coppice above almost any other habitat, feeding on the nuts and building nests in the tangle of stems. Nuthatches and woodpeckers work the older stools, and the cut stems themselves — left in habitat piles — rot down slowly and support beetles, fungi and the larvae of stag beetles.

Putting the Wood to Use

The pleasure of coppicing is that nothing need go to waste, and the craft uses are wonderfully varied.

  • Bean poles and pea sticks from straight rods cut on a five to seven year cycle.
  • Hurdles and wattle panels from hazel rods split or woven over a frame.
  • Thatching spars and binders from long, flexible rods cut on a longer rotation of ten to fifteen years.
  • Tool handles, walking sticks, chair frames and basketry from the cleanest, straightest stems.
  • Kindling and charcoal from the brash and crooked pieces.

Bundle your rods and store them off the ground under cover, and they will stay supple for months — ready for a winter evening of hurdle making by the fire.

author
Sophie Mercer

The Forest Roost shares practical, down-to-earth guidance on british woodland wildlife, nature-friendly gardening and rural crafts for readers across the UK.

Leave A Comment
Handpicked